Factory-direct pathology storage · Luoyang, Henan, China

Export enquiries: younuosh@foxmail.com +86 139 3881 2326
Best practice · 8 min read

FFPE Block Storage: Best Practices for Histology Laboratories

Paraffin blocks are stable, but not indefinitely and not under any conditions. Here is what actually degrades FFPE material in storage, and the cabinet details that slow it down.

An FFPE block is a tissue specimen suspended in wax. Both parts are chemically stable compared with a frozen section, which is why pathology archives are built around them. But wax softens with heat, oxidises slowly with light and air, and the tissue inside is only as good as the conditions around it.

Storage practice therefore has two goals: keep the block physically intact, and keep the tissue inside usable for re-cutting, immunohistochemistry and molecular testing years later.

What makes FFPE storage different from slide storage

Slides are a thin section on glass; blocks are a three-dimensional piece of wax and tissue. That changes the risks. A slide fails visibly, as a crack or a faded stain. A block can look perfect and still have lost antigenicity at the surface, or have wax that has become brittle enough to shatter when the microtome blade touches it.

The practical difference is that block storage is mostly about the environment, while slide storage is mostly about mechanical protection. A FFPE block storage cabinet should therefore be assessed on how well it buffers temperature and excludes light and dust, not only on drawer count.

Temperature and humidity

Ambient laboratory temperature is acceptable for long-term block storage, provided it is stable. Paraffin softens noticeably above about 30 degrees Celsius, and blocks stored near a window, a drying oven or a hot water line will deform and stick together. Keep cabinets away from heat sources and out of direct sun.

Humidity matters less for the wax than for the label and the cassette. Sustained damp causes mould on paper labels and corrosion on metal cassette lids, and repeated condensation cycles embrittle the wax surface. Two practical measures: leave a 50 mm gap between the cabinet back and the wall so air can move, and avoid outside walls that condense in winter.

If the archive room smells of old paraffin when you open the door, the ventilation is inadequate. Blocks absorb and re-release volatile compounds; the smell is a signal, not a nuisance.

Light, dust and pests

Light exposure degrades nucleic acids at the block surface over years, which matters for archives that may be asked for molecular testing a decade later. Closed steel drawers are the simplest control: a drawer front blocks light completely, where open shelving does not.

Dust is a contamination risk during re-cutting, and insect activity is a genuine problem in warm climates. Steel cabinets with closed drawers and tight joints address both. Avoid cardboard boxes inside the archive, and do not store blocks in the same room as food or biological waste.

Organisation and traceability

A block that cannot be found is not archived; it is lost. Three rules cover most failures:

  • One sequence. File by accession number in one direction, and never mix years in the same drawer.
  • Visible ranges. Label each drawer front with the accession range it holds. Anyone should be able to find a case without opening more than one drawer.
  • Matching slides. Keep slide and block sequences aligned, so the same case sits in the same relative position in both cabinets.

Our tissue block filing cabinets use removable divider strips for exactly this reason: a case series that grows from two rows to four can be re-divided without emptying the drawer.

Handling for re-cutting and molecular work

Every retrieval is a small stress event. Blocks pulled for consultation, re-cuts or molecular testing should be returned to the same position, not to a "pending" pile. Keep a retrieval log, and set a rule that blocks leave the archive only in a tray, never loose in a pocket or a bag.

For molecular testing, take the section from the block face rather than trimming deeply, and record how much material was removed. Repeated re-cutting of the same block is the main reason old blocks become unusable.

Retention and disposal

Retention periods for pathology blocks are set by national or regional regulation and by institutional policy, and they differ substantially between jurisdictions. Do not copy a period from another country's guideline. Confirm your own requirement in writing, and record the disposal decision with the case file when the period ends.

A five-point storage audit

  • Is the archive room temperature stable and below the point where wax softens?
  • Are cabinets off outside walls and away from heat sources?
  • Does every drawer front show an accession range?
  • Is there a retrieval log, and is it used?
  • Is there space to expand without moving the existing sequence?

If all five are answered, the storage is doing its job. If two are not, the cabinet is probably not the problem; the process around it is.

Common questions

Should FFPE blocks be stored in a cold room?

Not usually. Cold storage adds condensation risk each time a block is brought out. Stable ambient temperature, away from light and heat, is the normal specification.

Can blocks and slides be stored in the same cabinet?

They can share a room but not a drawer. Slides need upright slots; blocks need rows sized for cassettes. Use separate cabinet types with matched numbering.

How full should a drawer be?

About 90 percent. Overfilling makes retrieval slow and abrades cassette edges; underfilling lets blocks slide out of sequence when the drawer moves.


Need this applied to your own archive? Send annual block or slide counts and the retention period, and we will return a capacity calculation with a suggested cabinet layout. Request a quote.

Need a cabinet sized to your archive?

Send your block or slide counts, retention period and room plan. We will return a capacity calculation and a quotation within two working days.