A cabinet can be the right capacity and still be the wrong purchase, because the room will not take it. The measurements that matter are rarely on a drawing: they are the door width, the drawer projection, the skirting board and the floor fall.
Take these six measurements before you compare models. Each one has caught out a laboratory that ordered from a catalogue.
1. Usable wall length, not room length
Measure the wall, then subtract everything that interrupts it: radiators, pipe boxes, sockets, door swings, emergency exits and skirting. A 6 m wall with a 900 mm door and two radiators often has 4.2 m of usable run.
Then divide by the cabinet width. A standard section is 515 mm wide, so 4.2 m takes eight columns. If the archive needs twelve, the room is already short and the answer is a different layout, not a different cabinet.
2. Drawer projection into the aisle
A 480 mm deep drawer pulls out almost its full depth. Add that to the standing space a person needs and you get the real aisle requirement: roughly 480 mm of drawer plus 700 to 800 mm of working space.
Measure the aisle with the door closed, then again with the largest door in the room open. If a cabinet would sit behind a door swing, the drawer will be unusable for part of the day.
3. Door widths, lifts and corners
Sections ship separately, so the constraint is the largest single section: 515 mm wide, 480 mm deep, 360 mm high. That passes most doors. A fully assembled four-section stack does not.
Check the route from the loading bay: door frames, lift dimensions, stair turns and any step at the entrance. A 100 mm step is enough to require two people and a ramp.
4. Floor level and loading
Steel cabinets need a flat floor. A 10 mm fall across a 3 m wall means the stack leans, drawers bind, and the corner pins do not seat. Measure with a straight edge and a level, not by eye.
For upper floors, ask a structural engineer about the loaded weight. Blocks are lighter than slides per unit volume, but a full archive is still one of the heavier loads in a hospital building.
5. Working height and ceiling
Four sections give a 1,520 mm cabinet; the top drawer sits around 1,480 mm. That is comfortable for most staff. Five sections push the top drawer past 1,800 mm, where it is reached less often and loaded more carefully.
Also measure the ceiling and any services above the cabinet. A sprinkler head or cable tray at 2,000 mm rules out a five-section stack regardless of preference.
6. Heat, water and ventilation
Keep cabinets off outside walls that condense, and away from ovens, autoclaves and hot water lines. Leave a 50 mm gap behind the cabinet so air can move.
If the room also handles solvents, the archive should be separated or ventilated. Solvent vapour that reaches a closed drawer will be absorbed by the blocks.
Measurement checklist
- Usable wall length after doors, radiators and sockets
- Aisle width with drawers open
- Largest door frame and the delivery route
- Floor level across the full run
- Ceiling height and services above
- Distance to heat sources and sinks
With these six numbers, choosing between a 515 mm and a 450 mm cabinet, or between static and compact shelving, becomes arithmetic rather than guesswork.
Common questions
How much space should I leave above the cabinet?
At least 300 mm for cleaning access and to keep the top clear of sprinklers. More if the ceiling carries services.
Can a cabinet stand in front of a window?
It can, but light and solar gain make it a poor position for long-term block storage. Use that wall for something else.
Need this applied to your own archive? Send annual block or slide counts and the retention period, and we will return a capacity calculation with a suggested cabinet layout. Request a quote.