Factory-direct pathology storage · Luoyang, Henan, China

Export enquiries: younuosh@foxmail.com +86 139 3881 2326
Storage basics · 6 min read

Tissue Cassette Types and What They Mean for Storage

Two laboratories with identical cabinets can store very different numbers of blocks. The difference is usually the cassette, not the cabinet.

A cassette looks like a trivial variable: a plastic box with a lid. But its wall thickness, lid design and label decide how many fit in a drawer, how well they stand upright, and whether a row stays in sequence when the drawer moves.

What a cassette actually is

A standard cassette is a plastic frame with a perforated base that holds the tissue during processing and embedding. After embedding it becomes the block: the wax-filled cassette that goes to the microtome and then to the archive.

Three dimensions matter for storage: length, width and wall thickness. Length and width are standardised enough that most drawers accept most cassettes. Thickness is not.

Wall thickness and capacity

A 4 mm cassette and a 5 mm cassette differ by 25 percent in the space they occupy. In a drawer that holds 800 cassettes at 4 mm, the same drawer holds roughly 640 at 5 mm.

That is not a rounding error. Across a four-section cabinet the difference is about 3,000 blocks, or nearly a fifth of the archive. If you are planning capacity, measure a cassette from your own stock rather than assuming.

Lids, locks and stacking

Cassettes with attached lids sit slightly proud of the frame. In a shallow drawer that is fine; in a tightly packed row it stops the next cassette sitting flat. Lidded cassettes also tend to be taller overall, which matters when drawers are stacked at 360 mm section height.

Biopsy cassettes are smaller and thinner. They fit any drawer but slide out of sequence unless dividers are set for the smaller footprint.

Labels and printing

A printed cassette with a large label area is easier to read but takes more space in a row. Laser-etched cassettes have no label thickness but need consistent contrast to be legible under archive lighting.

Whatever the method, the label must survive alcohol, xylene and years of storage. Faded labels are the most common reason a block cannot be matched to its case.

Filing implications

Cassettes are usually filed upright in rows, with the label facing the drawer front. That works if the drawer is deep enough for the cassette to stand without leaning, and if dividers hold the row under slight compression.

Where a laboratory uses ten-cell cassette boxes instead of loose rows, the drawer needs vertical slots rather than horizontal rows. That is a different drawer interior, which is why tissue cassette storage cabinets are specified separately from block filing cabinets.

A practical planning rule

  • Measure ten cassettes from current stock and take the average thickness.
  • Divide the usable drawer length by that thickness to get a realistic row count.
  • Reduce by 10 percent for dividers and handling gaps.
  • Check that the drawer height accepts the cassette standing upright with its lid.

Do this once, write the number on the cabinet specification, and the archive plan stops drifting every time a supplier changes cassette moulds.

Common questions

Do all cassettes fit standard cabinets?

Most do, but capacity changes. Very thick or unusually tall cassettes may need a deeper drawer or a different section height.

Should blocks be stored in cassette boxes?

Boxes suit transport and bulk handling; drawers suit retrieval by accession. Most archives file loose blocks in drawers and use boxes only for transfer.


Need this applied to your own archive? Send annual block or slide counts and the retention period, and we will return a capacity calculation with a suggested cabinet layout. Request a quote.

Need a cabinet sized to your archive?

Send your block or slide counts, retention period and room plan. We will return a capacity calculation and a quotation within two working days.